Pole trimmers come in all shapes and sizes, and as a result, there are a variety of attachments that can be used with them. However, when it comes to replacing the rope on your pole trimmer, you might find that it’s a bit of a hassle. In this article, we’ll show you how to replace the rope on a pole trimmer using simple tools and step-by-step instructions.
What is a Pole Trimmer?
A pole trimmer is a versatile tool that can be used for many different tasks around the yard. A pole trimmer typically has an electric motor, a blade, and a handle. The blade can be used to trim branches and bushes close to the ground, or it can be used to cut tall grasses.
If you have a pole trimmer with an automatic feed system, you will need to replace the rope periodically. You can buy replacement ropes in bulk at most hardware stores or online. To install the new rope, first remove the old one from the pole trimmer. Then unthread the rope from the spool and tie a knot in the end. Slide the new rope onto the spool and re-tie the knot. Push the end of the rope through the hole in the handle and re-attach the clip.
How to Replace Rope on a Pole Trimmer
Replacing rope on a pole trimmer is a simple operation that can be done by anyone with basic mechanics skills. Rope can wear down over time, particularly if the trimmer is used frequently on tough surfaces. When this happens, the rope becomes brittle and can break easily. If the rope breaks while you’re using the trimmer, it can cause serious injury.
Here are instructions on how to replace rope on a pole trimmer:
- Remove the engine cover. There are several screws that need to be removed in order to do this, so be prepared with a Phillips screwdriver. Once the cover is off, you’ll see the engine and transmission.
- Remove the three screws that hold the tensioner pulley in place (two on each side). Once these screws are out, gently pull the pulley off of the belt drive and set it aside.
- Remove the eight screws that secure the guard to the engine housing (four per side). Once these screws are out, carefully lift off the guard and set it aside.
- Locate and remove the four screws that secure the upper suspension arm to the engine housing (two per side). Once these screws are
Guidelines for Replacing Rope on a Pole Trimmer
If your pole trimmer rope has become worn out or frayed, it’s time to replace it. Here are guidelines for replacing rope on a pole trimmer:
- Locate the spool that holds the rope. On most models, this is located on the bottom of the machine.
- Remove the old rope by pulling it off the spool. Make sure to keep the end of the old rope that’s still attached to the spool.
- Thread a new piece of rope onto the spool and pull it tight. Make sure to wrap the new rope around the spool a few times to make sure it’s secure.
- Put the spool back in place and tighten the screws that hold it in place.
Conclusion
If your pole trimmer’s rope is starting to fray, it might be time to replace it. Rope is an essential part of a pole trimmer and should be replaced as soon as it starts to show signs of wear or tear.